Minwax® Teak Oil protects dense woods and
enhances wood grain by penetrating into wood pores, restoring the wood’s
natural warmth and richness. It is recommended for outdoor and indoor
furniture, and on marine surfaces above the water line. Use Minwax®
Teak Oil periodically to refresh your dense woods and help protect them
from moisture and UV rays.
Directions
SURFACE
PREPARATION:
•Surface
must be dry and free of old finishes such as varnish, paint, polish,
wax, grease, dirt, and subsurface moisture.
•If desired, sand to obtain smooth, uniform surface.
APPLICATION:
•Lightly
shake container for 15 – 20 seconds.
•Brush or wipe on a generous amount of Minwax® Teak Oil.
•Allow Minwax® Teak Oil to penetrate into wood for 5 –
10 minutes. Do not wipe off any excess.
•Apply a second coat and leave on for an additional 15 –
20 minutes. (Do not leave product on wood in excess of 30 minutes total.)
•Wipe surface completely dry.
•Ready for use in 6 – 8 hours.
CLEAN UP: Use mineral spirits or paint thinner following manufacturer's
safety recommendations.
COVERAGE: 125 – 150 sq. ft. per quart.
STORAGE: Store at room temperature.
MAINTENANCE: Periodically reapply Minwax®
Teak Oil to dry, worn out wood in order to restore effectiveness of
finish.
NOTE:
Above dry times and coverage rates are based on good ventilation, temperature
of 77° and 50% relative humidity. Lower temperature, higher humidity,
lack of ventilation will extend dry times. Always spot test on inconspicuous
area to ensure satisfactory results.
